Crusher Run Calculator

Quick answer#

Crusher run is commonly used as a compactable base. The key distinction in this calculator is that finished geometric volume, material density and added order allowance remain separate rather than being collapsed into an unexplained rule of thumb.

The live result shows both volume and mass because suppliers may quote either. Every density preset is editable; it is not a promise that locally supplied material has that unit weight.

Formula and calculation method#

Enter the finished footprint and specified depth. If a supplier provides tons per cubic yard, convert that to density or use the Cubic Yards to Tons Calculator. The load estimate uses the capacity entered and always rounds up.

The shared calculation path is:

1. Determine measured volume in cubic metres internally.
2. Calculate base mass as volume × bulk density.
3. Calculate order quantity as base quantity × (1 + order allowance ÷ 100).
4. Divide order mass by entered bag or load capacity and round up to whole units.
5. Apply optional pricing only from the price, fixed delivery cost and tax entered by the user.

One cubic yard is exactly 27 cubic feet. One US short ton is exactly 2,000 pounds. Metric mode reports cubic metres and metric tonnes.

Worked example#

A 40 ft × 10 ft base at 4 in deep has about 4.938 yd³ of geometric volume. At 110 lb/ft³, the base mass is about 7.333 short tons. With a 10% order allowance, the result is about 5.432 yd³ and 8.067 short tons.

The example is reproducible in the calculator, but a purchase decision should use measurements and density for the actual project and product.

Choosing a density#

Bulk density is mass per occupied bulk volume, including the spaces between particles. It is not the same as the solid-rock particle density. Moisture, gradation, particle shape, source and test procedure can all affect it.

The planning presets are intentionally editable sensitivity values. Prefer, in order:

1. A density or tons-per-yard figure for the exact supplier product.
2. Project test or specification data representing the required material condition.
3. An explicitly labelled planning value that is later replaced before ordering.

ASTM C29/C29M describes a standardized method for determining aggregate bulk density (unit weight) and voids. The calculator does not claim that its editable presets are laboratory results under that standard.

Order allowance, bags and loads#

The order allowance is shown separately and applied once. Do not use it to duplicate waste, settlement or compaction already built into a supplier recommendation or project quantity.

Bag and load counts use the capacities entered and round upward. They are planning divisions only. Confirm package weight, supplier minimums, legal payload, axle limits, access and split-delivery requirements independently.

Assumptions and limitations#

This calculator does not specify excavation depth, subgrade preparation, geotextile, drainage, gradation, lift thickness, moisture conditioning or compaction testing. Those decisions belong to the project design and applicable specifications.

Cost is optional and uses only the entered rate per short ton or metric tonne, fixed delivery cost and tax. Currency selection changes the label but does not perform exchange-rate conversion. Results are estimates, not bids, engineering designs, specifications or guarantees of availability.

Sources and methodology#

• NIST: SI Units — Volume — definition of volume and the cubic metre as the SI derived unit.
• NIST: SI Units — Mass — mass and SI-unit reference.
• NIST SP 811 conversion factors — U.S. customary and SI conversion basis.
• ASTM C29/C29M — standard test method for aggregate bulk density (unit weight) and voids.
• Vulcan Materials aggregate tonnage estimator — industry example showing aggregate estimates depend on entered dimensions and density.

Sources identify the measurement and density methodology. They do not certify a specific material preset, local product or project design.